ATLS Whole House Air Purifier ATLS-STUV36 Model - HVAC Air Purifier   

• Proven to kill 99.9% of airborne germs
• Home purifier
• Air Sanitizers
• Single 254nm dual tube lamp
• No Ozone
• Installation takes less than 15 minutes
• 1 year limited manufacturer warranty

 

1-Year Limited Manufacturer's Warranty

•  Model ST-UV36
• 13000 hours UV bulb lifetime 
• 254 NM UVC 
• 36 W power
• HVAC systems and indoors
• 110V or 220V Voltage
• Work within 1500 sqft
• Bulb diameter: 17mm, length 411 mm
• 254*160*56 mm Base
• 475*260*125 mm dimensions 
• 1.5 KG Net Weight
• 2.2 KG Gross weight

1. Disconnect power to the HVAC system before installing the unit.
2. Need to create a template and tape it to the duct work in the intended installation position.
3. Drill pilot holes as required with a 3/32” drill bit.
4. Cut out the appropriate hole on the HVAC pannel.
5. Remove any burrs and be sure duct surface is flat after cutting the hole(s).
6. Install the bulb(s) in the unit by sliding the bulb in from the outside until the bulb snaps into place. Insert the unit into the metal duct cut out. If you touch the bulb with your hands, use a cloth to wipe any fingerprints from the bulb(s).
7. Attach the unit to duct work with the supplied 4 sheet metal screws using a ¼” nut driver. Make sure to tighten screws evenly. The unit has a factory installed gasket that ensures a tight seal between the unit and the duct work. Be sure the unit is flat against the duct work on all sides. CAUTION: DO NOT OVERTIGHTEN SCREWS.
8. Plug the unit into a grounded 120 volt power outlet.
9. Turn unit on and verify that the LED indicator light(s) located near the on/off switch is/are illuminated.
10. The switch is in the on position when the solid line on the switch is pressed down.
11. Reconnect the power to the HVAC system
12. The unit is now operational and does not need to be powered off unless cleaning or bulb replacement is necessary